4 Passenger Rear

SEAT - 4 PASSENGER REAR

REMOVAL

1. Disconnect each shoulder belt connector located below the upper anchor bolt.

Fig. 11:

2. Remove nuts attaching each corner of seat riser to floor pan (Fig. 11).
3. Lift seat upward to separate from studs.
4. Separate seat from vehicle.

INSTALLATION

1. Position seat in vehicle.
2. Position risers onto studs.
3. Install nuts attaching each corner of seat riser to floor pan. Tighten the nuts to 22 N.m (16 ft. lbs.) torque.
4. Connect each shoulder belt connector at the upper anchor bolt.

NOTE: If studs need to be replaced, install studs into floor pan and tighten to 39 N.m (28 ft. lbs.) torque.