Oil Pump Bushing Removal

OIL PUMP BUSHING REMOVAL
1. Position pump housing on clean, smooth surface with gear cavity facing down.





2. Remove bushing with Tool Handle C-4171 and Bushing Remover SP-3550 (Fig. 114).

REACTION SHAFT SUPPORT BUSHING REMOVAL





1. Assemble Cup Tool SP-3633, Nut SP-ll91 and Bushing Remover SP-5301 (Fig. 115).
2. Hold cup tool firmly against reaction shaft. Thread remover tool into bushing as far as possible by hand.
3. Using wrench, thread remover tool an additional 3-4 turns into bushing to firmly engage tool.
4. Tighten tool hex nut against cup tool to pull bushing from shaft. Clean all chips from shaft and support after bushing removal.