Seat Track: Service and Repair
REMOVALIf the driver side front power seat is in the raised position, it is possible to access and remove the seat and/or the power seat track and motors assembly without removing the seat riser, go to Step 6. If the driver side front power seat is not in the raised position, the seat assembly must be removed from the passenger compartment for service of the power seat adjuster and motors. The seat assembly includes the seat, the seat track and the seat riser. Proceed as follows:
1. Disconnect and isolate the battery negative cable.
Seat Riser Rear Shield Remove/Install:
2. Remove the four fasteners that secure the lower portion of the rear shield to the seat riser.
Fig. 4 Power Seat Track Remove/Install:
3. Unplug the power seat track and seat belt switch wire harness connectors.
4. Remove the four nuts that secure the seat riser to the studs on the floor panel. The rear nuts are accessed by lifting up the seat riser rear shield.
5. Remove the seat assembly from the passenger compartment and place it on a suitable work surface for further service.
6. Remove the four screws that secure the power seat track and motors assembly to the bottom of the seat cushion frame.
7. Unplug the wire harness connector between the power seat switch and the power seat track and motors wire harnesses.
8. Remove the seat cushion frame from the power seat track and motors unit.
9. Remove the four nuts that secure the power seat track and motors unit to the seat riser.
10. Remove the power seat track and motors unit from the seat riser.
INSTALLATION
1. Position the power seat track unit on the seat riser.
2. Install the four nuts that secure the power seat track unit to the seat riser. Torque the nuts to 22.6 Nm (200 in. lbs.).
3. Install the seat cushion frame on the power seat track unit. Torque the fasteners to 22.6 Nm (200 in. lbs.).
4. Connect the wire harness connector between the power seat switch and the power seat track wire harnesses.
5. Install the four screws that secure the power seat track to the bottom of the seat cushion frame. Torque the fasteners to 22.6 Nm (200 in. lbs.).
6. Install the seat assembly in the passenger compartment. Refer to Body for the procedure.
7. Connect the power seat track and seat belt switch wire harness connectors.
8. Install the four fasteners that secure the lower portion of the rear shield to the seat riser.
9. Connect the battery negative cable.