Side/Rear Door Ajar Switches

Side/Rear Door Ajar Switches Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.

Fig. 3 Door Ajar Switch Remove/Install - Side Or Rear Door:

2. Unscrew the door ajar switch from the pillar (Fig. 3).
3. Pull the door ajar switch away from the pillar far enough to access and unplug the two wire harness connectors from the switch.
4. Remove the door ajar switch from the vehicle.
5. Reverse the removal procedures to install. Tighten the switch to 5.6 Nm (50 in. lbs.).

INSTALLATION
1. Connect the wire harness connectors to the switch
2. Install the switch to the pillar Tighten the switch to 5.6 Nm (50 in lbs)
3. Connect the battery negative cable.