Installation

INSTALLATION
1. Snap the cable into the transmission bracket so the retaining ears are engaged and snap the cable eyelet onto the manual control lever ball stud.
2. Lower vehicle.
3. Route cable through hole in dash panel.
4. Seat the cable mounting bracket to dash panel and install retaining nuts to hold the cable housing bracket to the dash panel.
5. Tighten the nuts to 34 Nm (25 ft. lbs.).
6. Place the transmission manual shift lever in the "PARK" detent (rearmost) position and rotate prop shaft to ensure transmission is in PARK.





7. Connect shift cable to the steering column shift lever (Fig. 108) by snapping the cable retaining ears into shifter bracket and snapping the cable eyelet on the steering column ball stud.
8. Lock the shift cable adjustment by pressing the cable adjuster lock upward until it snaps into place.
9. Check for proper operation of the transmission range sensor.
10. Adjust the gearshift cable as necessary.