Oil Cooler: Service and Repair

Oil Cooler & Lines

REMOVAL
1. Drain cooling system.

Fig.103:

2. Disconnect oil cooler inlet and outlet hoses (Fig. 103).
3. Remove oil filter.

Fig.104:

4. Remove oil cooler attachment fitting (Fig. 104).
5. Remove oil cooler.

INSTALLATION
1. Lubricate seal and position oil cooler to connector fitting on oil filter adapter (Fig. 104).

NOTE: Position the flat side of oil cooler parallel to oil pan rail.

2. Install oil cooler attachment fitting and tighten to 27 Nm (20 ft. lbs.) (Fig. 104).
3. Install oil filter.
4. Connect oil cooler inlet and outlet hoses (Fig. 103).
5. Fill cooling system.