Rear

REMOVAL
1. Raise and support the vehicle.
2. Remove the wheel and tire assembly.
3. Drain a small amount of fluid from master cylinder brake reservoir with a clean suction gun.
4. Bottom the caliper pistons into the caliper by prying the caliper over.





5. Remove the caliper mounting bolts .
6. Remove the disc brake caliper from the mount.

CAUTION: Never allow the disc brake caliper to hang from the brake hose. Damage to the brake hose will result. Provide a suitable support to hang the caliper securely.

7. Remove the inboard and outboard brake pads.
8. Remove the anti-rattle clips.
9. Remove the caliper adapter mounting bolts.

INSTALLATION- REAR
1. Install the caliper adapter mounting bolts. Tighten the mounting bolts to 176 Nm (130 ft. lbs.).
2. Install the anti-rattle clips.
3. Install the inboard and outboard pads.
4. Install the caliper mounting bolts.
5. Install the tire and wheel assembly