Rear

REMOVAL
1. Raise and support vehicle.
2. Remove the wheel and tire assembly.





3. Remove the caliper brake hose banjo bolt, washers and hose.
4. Remove the caliper mounting slide pin bolts.





5. Remove the caliper from vehicle.
6. Remove anti-rattle springs.

INSTALLATION
1. Install caliper to the caliper adapter.
2. Coat the caliper mounting slide pin bolts with silicone grease. Then install and tighten the bolts to 32 Nm (23.5 ft. lbs.).

CAUTION: Verify brake hose is not twisted or kinked before tightening fitting bolt.

3. Install the brake hose to the caliper and install the brake hose banjo bolt if removed with new seal washers and tighten fitting bolt to 28 Nm (250 inch lbs.).
4. Bleed the base brake system.
5. Install the wheel and tire assemblies.
6. Remove the supports and lower the vehicle.
7. Verify a firm pedal before moving the vehicle.