Cruise Control Switch: Service and Repair

REMOVAL
Depending on engine control computer (JTEC having a 3-plug connector or 5.7L V-8 NGC having a 4-plug connector), 2 types of switches are used. Both types of switches are internally and externally different. The switches used with the NGC system have attached pigtail leads. The switch used with the JTEC system does not have an attached pigtail lead.

Fig.10 Speed Control Switches (Except 5.7L V-8 Engine):

Fig.11 Speed Control Switches (With 5,:

1. Remove switch mounting screw.
2. Pull switch from steering wheel.
3. Unplug electrical connector from switch or, switch pigtail wire harness from steering wheel wire harness and remove switch.

INSTALLATION
1. Plug electrical connector into switch or connect pigtail wire harness to steering wheel wire harness. Be sure wires are not pinched.
2. Position switch to steering wheel.
3. Install switch mounting screw and tighten. Refer to torque specifications.