A/T - Stuck in 1st or 3rd Gear/No MIL or DTC's Present
NUMBER: 18-036-02GROUP: Vehicle Performance
DATE: Dec. 6, 2002
THIS BULLETIN IS BEING PROVIDED IN ADVANCE. THE MDS2 MUST BE OPERATING WITH CIS CD2123 OR HIGHER, AVAILABLE DECEMBER 23, 2002.
SUBJECT:
Flash: Update to Transmission OBDII calibrations
OVERVIEW:
This bulletin involves selectively erasing and reprogramming the JTEC Powertrain Control Module (PCM) with new software (03CAL17A).
MODELS:
2003 (DR) Ram Truck
NOTE:
THE BULLETIN APPLIES TO VEHICLES EQUIPPED WITH A 5.9L 24-VALVE DIESEL ENGINE (SALES CODES ETC, OR ETH) AND 47RE AUTOMATIC TRANSMISSION (SALES CODE DGP) AND BUILT BEFORE SEPTEMBER 25, 2002.
SYMPTOM/CONDITION:
Customers with California emission vehicles may complain the vehicle will not shift out of 1st gear or is stuck in 3rd gear. No Diagnostic Trouble Code (DTC) will be generated and no MIL illumination will occur.
DIAGNOSIS:
If the vehicle is equipped with a Cummins Diesel engine, 47RE Automatic Transmission, and was built before September 25, 2002, perform the Repair Procedure.
PARTS REQUIRED
EQUIPMENT REQUIRED
REPAIR PROCEDURE:
NOTE:
WHENEVER A PCM/TCM IS REPLACED OR REPROGRAMMED, THE SOFTWARE IN THE CONTROLLER AND DRBIII(R) MUST BE VERIFIED AS HAVING THE LATEST REVISION LEVEL.
1. Connect a battery charger and set as close to 14 volts charge as possible.
2. Flash the PCM using the MDS2 (Mopar Diagnostic System) and DRBIII(R).
NOTE:
DUE TO THE PCM REPROGRAMMING PROCEDURE, A DTC MAY BE SET IN OTHER MODULES (TCM, BCM, MIC, SKIM, ETC.) WITHIN THE VEHICLE, IF SO EQUIPPED. SOME DTC'S MAY CAUSE THE MIL TO ILLUMINATE. ALL DTC'S RELATE TO A LOSS OF COMMUNICATIONS WITH THE MODULE THAT IS BEING REPROGRAMMED. CHECK ALL MODULES, RECORD THE FAULTS, AND ERASE THESE FAULTS PRIOR TO RETURNING THE VEHICLE TO THE CUSTOMER. ERASE ANY FAULTS IN THE PCM ONLY AFTER ALL OTHER MODULES HAVE HAD THEIR FAULTS ERASED.
NOTE:
THE FOLLOWING STEPS ARE REQUIRED BY LAW.
3. Type the necessary information on the "Authorized Software Update Label p/n 04669020 (Fig. 1). Attach the label to the PCM and/or TCM as necessary and cover the label(s) with the clear plastic overlay.
4. Type the necessary information on the "Authorized Modification Label p/n 04275086AB and attach near the VECI label (Fig. 2).
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE
FAILURE CODE