Console Lamp: Service and Repair

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Open up console lid.
3. Remove console tray.
4. Using a trim stick (special tool #C-4755) or equivalent, gently pry down on lamp. Make sure not to let lamp fall into console base.

NOTE: If preferred, a 5/16 piece of hose approximately 4-6 inches long may be used to pull lamp from socket. Push hose over end of lamp and pull down.

INSTALLATION

NOTE: If preferred, a 5/16 piece of hose approximately 4-6 inches long may be used to install the new lamp. Push lamp into hose just far enough to hold bulb. Locate the socket slot and push firmly up. Make sure not to let lamp fall into console base. When bulb is seated, twist hose 1/4 turn to remove from lamp.

1. Place lamp in socket slot and push firmly up. Make sure not to let lamp fall into console base.
2. Install the console tray.
3. Close console lid.
4. Connect the battery negative cable.