Driver Seat Switch

1. Remove the power seat switch, refer to the Switch Removal and Installation procedures.
2. Using an ohmmeter, check pin #1 in the power seat switch connector receptacle for continuity to ground. It should be present. If OK, go to Step 3. If not OK, repair the open ground circuit as required.
3. Using an voltmeter, check pin #5 of the wire harness connector for the power seat switch for battery current. It should be present. If OK, go to Step 4. If not OK, repair the open voltage supply circuit as required.

Driver Seat Switch Continuity Test Table:

Seat Switch Pin Call - Out:

4. Using an ohmmeter, test the power seat switch continuity as shown in the Test Table at the pins in the switch connector receptacle. If there is no continuity at any of the switch positions, replace the power seat switch.