Front

REMOVAL
1. Disconnect and isolate the battery negative cable.

Integrated Power Module - Typical:

2. Unlatch and remove the cover from the Integrated Power Module (IPM).
3. See the fuse and relay layout map molded into the inner surface of the IPM cover for front blower motor relay identification and location.
4. Remove the front blower motor relay from the IPM by pulling the relay straight up.

INSTALLATION
1. Refer to the fuse and relay layout map on the inner surface of the integrated power module (IPM) cover for front blower motor relay identification and location.
2. Position the front blower motor relay to the proper receptacle in the IPM.
3. Align the front blower motor relay terminals with the terminal cavities in the IPM receptacle.
4. Push down firmly on the front blower motor relay until the terminals are fully seated in the terminal cavities in the IPM receptacle.
5. Install the cover onto the IPM.
6. Reconnect the negative battery cable.