Rear

REMOVAL
1. Disconnect and isolate the battery negative cable.

Integrated Power Module - Typical:

2. Unlatch and remove the cover from the Integrated Power Module (IPM).
3. See the fuse and relay layout map molded into the inner surface of the IPM cover for rear blower motor relay identification and location.
4. Remove the rear blower motor relay from the IPM.

INSTALLATION
1. See the fuse and relay layout map molded into the inner surface of the Integrated Power Module (IPM) cover for rear blower motor relay identification and location.
2. Position the rear blower motor relay to the proper receptacle in the IPM.
3. Align the rear blower motor relay terminals with the terminal cavities in the IPM relay receptacle.
4. Push down firmly on the rear blower motor relay until the terminals are fully seated in the terminal cavities in the IPM receptacle.
5. Install the cover onto the IPM.
6. Reconnect the battery negative cable.