Side Impact Airbag Control Module

REMOVAL

NOTE: Diagnose the SIACM using the service/diagnostic manual.

1. Disconnect and isolate the battery negative cable terminal.
2. Remove the lower B-pillar trim from the appropriate side of the vehicle. Refer to Body, Interior, B-Pillar Lower Trim, REMOVAL.
3. Remove the three SIACM retaining screws and remove the module from the vehicle.
4. Disconnect the SIACM electrical connector.

INSTALLATION

WARNING: DO NOT INSTALL THE SIACM IF THE MOUNTING LOCATION IS DEFORMED OR DAMAGED.

1. Connect the SIACM electrical connector.
2. Place the module in the slot on their respective B-pillar. Install the three SIACM retaining screws. Torque screws to 5.7 - 7.9 Nm (50 - 70 lbs.).

CAUTION: Use the correct screws when installing the SIACM.

3. Install the lower B-pillar trim on the appropriate side of the vehicle. Refer to Body, Interior, B-Pillar Lower Trim, INSTALLATION.

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. REFER TO ELECTRICAL, RESTRAINTS, DIAGNOSIS AND TESTING - AIRBAG SYSTEM FIRST.