Clutch Pedal Interlock Switch (LHD)
CLUTCH PEDAL INTERLOCK SWITCH - LHDREMOVAL
1. Disconnect battery negative cable.
Fig. 23:
2. Remove instrument panel lower silencer (Fig. 23).
Fig. 24:
3. Remove knee bolster (Fig. 24).
Fig. 25:
4. Disconnect interlock switch connector (Fig. 25).
5. Remove interlock switch by depressing four (4) plastic wing tabs, and sliding switch through mounting bracket (Fig. 25). If difficulty is encountered gaining access to and removing interlock switch, removing the upstop switch/bracket assembly (Fig. 25) allows for over-travel of the pedal, giving more room for interlock switch access.
6. Remove interlock switch harness from pedal bracket at retainer. Remove switch.
INSTALLATION
Fig. 28:
1. Install interlock switch into pedal bracket hole, and secure harness with retainer as shown in (Fig. 28). Make sure switch wing tabs are fully expanded.
2. Connect interlock switch connector.
3. Install knee bolster (Fig. 24).
4. Install instrument panel lower silencer (Fig. 23).
5. Connect battery negative cable.
6. Verify function of starter interlock switch. Switch must actuate when pedal is depressed.