Clutch Pedal Interlock Switch (RHD)
CLUTCH PEDAL INTERLOCK SWITCH - RHDREMOVAL
1. Disconnect battery negative cable.
Fig. 23:
2. Remove instrument panel lower silencer (Fig. 23).
Fig. 24:
3. Remove knee bolster (Fig. 24).
Fig. 26:
4. Remove master cylinder to clutch pedal pin retainer clip (Fig. 26). Disengage pushrod from clutch pedal pin.
5. Disconnect interlock and upstop switch connectors.
6. Disengage master cylinder grommet from dash panel.
7. Remove clutch master cylinder tubing from retainers in engine compartment.
8. Remove clutch master cylinder from dash panel/clutch pedal bracket by rotating 450 clockwise and pulling outward towards engine (Fig. 26).
Fig. 27:
9. Remove clutch pedal bracket assembly (Fig. 27).
Fig. 28:
10. Remove interlock switch harness from pedal bracket at retainer. Remove switch (Fig. 28).
INSTALLATION
1. Install interlock switch to pedal bracket assembly as shown in (Fig. 28). Secure connector with retainer to hole in bracket.
2. Install clutch pedal bracket assembly into position. Install pedal bracket mounting nuts and torque to 28 Nm (250 in. lbs.).
3. Connect interlock and upstop switch connectors.
4. Install clutch master cylinder into position and rotate 450 counter-clockwise to secure to pedal bracket (Fig. 26). Secure dash panel grommet and secure hydraulic pluming into dash panel retainers.
5. Connect master cylinder pushrod to clutch pedal pin and secure with retainer clip (Fig. 26).
6. Install knee bolster (Fig. 24).
7. Install instrument panel lower silencer (Fig. 23).
8. Connect battery negative cable.
9. Verify function of starter interlock switch. Switch must actuate when pedal is depressed.