Clutch Pedal Upstop Switch (LHD)

CLUTCH PEDAL UPSTOP SWITCH - LHD

REMOVAL
1. Disconnect battery negative cable.

Fig. 29:

2. Remove instrument panel lower silencer (Fig. 29).

Fig. 30:

3. Remove knee bolster (Fig. 30).

Fig. 31:

4. Remove upstop switch by depressing four (4) plastic wing tabs, and sliding switch through mounting bracket. If necessary remove mounting bracket and remove switch (Fig. 31).

INSTALLATION
1. Install upstop switch into bracket (Fig. 31). Ensure switch wing tabs are fully expanded. If removed, re-install bracket and torque to 13 Nm (115 in. lbs.).
2. Connect upstop switch connector.
3. Install knee bolster (Fig. 30).
4. Install instrument panel lower silencer (Fig. 29).
5. Connect battery negative cable.