Operation CHARM: Car repair manuals for everyone.
Home >> Dodge and Ram >> 2004 >> Durango 4WD V8-4.7L VIN N >> Repair and Diagnosis >> Heating and Air Conditioning >> Control Assembly >> Service and Repair >> A/C Heater Control - Front
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

A/C Heater Control - Front




REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, DISABLE THE AIRBAG SYSTEM BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE (GROUND) CABLE, THEN WAIT TWO MINUTES FOR THE AIRBAG SYSTEM CAPACITOR TO DISCHARGE BEFORE PERFORMING FURTHER DIAGNOSIS OR SERVICE. THIS IS THE ONLY SURE WAY TO DISABLE THE AIRBAG SYSTEM. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIR-BAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY OR DEATH.

1. Disconnect and isolate the negative battery cable.




2. Remove the center bezel (1) from the instrument panel, disconnect the wire harness connector(s) (2) from the A/C-heater control (3) and place the center bezel on a workbench. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, Instrument Panel Assembly Replacement, Instrument Panel Assembly




3. Remove the four screws (1) that secure the A/Cheater control (2) to the instrument panel center bezel (3).
4. Remove the A/C-heater control from the instrument panel center bezel.

INSTALLATION




1. Position the A/C-heater control (2) into the instrument panel center bezel (3).
2. Install the screws (1) that secure the A/C-heater control to the instrument panel center bezel. Tighten the screws to 2 Nm (17 in. lbs.).




3. Connect the wire harness connector(s) (2) to the A/C-heater control (3) and install the instrument panel center bezel (1). Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, Instrument Panel Assembly Replacement, Instrument Panel Assembly

4. Reconnect the negative battery cable.
pro multis · About Operation CHARM