P2115
SYMPTOMP2115-ACCELERATOR PEDAL POSITION SENSOR 1 MINIMUM STOP PERFORMANCE
WHEN MONITORED
Ignition on. During in plant mode the APP Sensors need to be checked to make sure that idle and full pedal travel can be reached on both sensors. The test for P2115 is only enabled once test for P2166 has passed.
SET CONDITION
APPS No.1 has failed to achieve the required minimum value during In Plant testing. One trip fault and the code will set within 5 seconds. Engine will only idle.
POSSIBLE CAUSES
- IN PLANT TEST FAILURE
- APPS RELEARN
Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Scan Tool Testing and Procedures
DIAGNOSTIC TEST
1. IN PLANT TEST FAILURE
Ignition on, engine not running.
Note: This DTC is set when the APP Sensors are learned in plant but do not reach the Minimum or Maximum voltage range. With a scan tool read DTCs. With the scan tool, erase DTCs. Start the engine. With the scan tool, read DTCs.
Note: Diagnose any APPS out of Range and 5-Volt Supply DTCs before continuing.
Is the DTC active at this time?
Yes>> Go To 2
No>> Perform (NGC) POWERTRAIN VERIFICATION TEST VER-5. Powertrain Verification Test - Ver 5
2. APPS RELEARN
With a scan tool select the ETC RELEARN function. Next, erase DTCs. Start the engine.
Does the DTC return?
Yes>> Replace the APPS Assembly per Service Information. After installation is complete, use a scan tool and select the ETC RELEARN function. Perform (NGC) POWERTRAIN VERIFICATION TEST VER-5.
No>> Test Complete.