Driver Rear Riser Sensor Out of Range High

Test 1 - 2:

Test 3 - 7:

Test 8 - 9:

SYMPTOM
DRIVER REAR RISER SENSOR OUT OF RANGE HIGH

WHEN MONITORED
Continuously when the PCI bus is active.

SET CONDITION
This condition is immediately set when the seat motor potentiometer feeds a value higher than the Memory Seat/Mirror/Adjustable Pedals Module has stored in EEPROM. Code will remain for 50 ignition cycles.

POSSIBLE CAUSES
- Memory seat/mirror/adjustable pedals module sensor ground open
- Seat sensor ground wire open
- 5 volt supply shorted high
- Check voltage on rear riser position signal circuit
- Rear riser sensor high
- Check rear riser short to motor
- Seat 5 volt supply wire shorted to rear riser position signal circuit
- Memory seat/mirror/adjustable pedals module rear riser high
- Stored diagnostic trouble code