Incomplete Power Open - Excessive Hall Effect Signal

Test 1:

Test 2 - 7:

Test 8 - 10:

SYMPTOM
INCOMPLETE POWER OPEN - EXCESSIVE HALL EFFECT SIGNAL

WHEN MONITORED
Anytime the power sliding door is in the opening cycle.

SET CONDITION
If during an opening operation the PSD module detects an excessive hall effect signal time period, this code will set. Code will also set if obstacle detection becomes inoperative due to a hall effect sensor failure or high effort on door during power up.

POSSIBLE CAUSES
- DTC present
- Power sliding door module - hall effect open
- Lower drive unit
- Binding door
- Hall effect ground circuit open
- Door motor hall effect supply wire open
- Door motor hall effect supply wire short to ground
- Door motor hall effect signal wire open
- Door motor hall effect signal wire short to ground
- Door motor assembly