Carpets - Fold - In - Floor

CARPETS - FOLD - IN - FLOOR

REMOVAL

1. Remove floor mats.
2. Remove front seats.
3. Remove instrument panel lower console.
4. Remove the floor console base tray and disconnect wire connector from the base tray.
5. Remove heel blocker (plastic block below accelerator pedal).

Fig. 6:

6. Remove winch plug (spare tire winch) (Fig. 6).
7. Remove front cowl panels and sill plates.
8. Remove kick plate and heel pad at gas pedal
9. Remove seat belt anchors at the passenger side B-pillar and driver side C-pillars
10. Fold in floor second and third row seats. Refer to the Owner's Manual for the proper procedures.

Fig. 7:

11. Remove front carpet trim ring and cover (Fig. 7). Refer to Utility Storage Compartment.
12. Remove sliding door sill plates. Refer to Trim Panel.
13. Remove lower B-pillar trim covers.
14. Remove push pin fasteners attaching carpet to floor in front seat area.
15. Roll carpet from under instrument panel to center of sliding door.

Fig. 8:

16. Pull carpet out from under the quarter trim panel (Fig. 8).

Fig. 9:

17. Using a trim stick, release clips attaching third row carpet cover, and remove (Fig. 9).
18. Remove rear carpet screws attaching rear of carpet.
19. Roll and fold carpet forward away from rear door opening.
20. Remove carpet through sliding door opening.

INSTALLATION

1. Place carpet through sliding door opening into position.
2. Roll carpet rearward towards the rear door opening.
3. Roll carpet forward under instrument panel (Fig. 8).
4. Install push pins fasteners through carpet and grommet into floor to attach carpet to floor in front seat area.
5. Pull wire harnesses through the carpet as needed.
6. Smooth out the carpet and allowing weld studs to go all the way through the carpet.
7. Install rear push pins fasteners attaching rear of carpet.
8. Place third row carpet cover into position and press clips into position (Fig. 9).
9. Slide the carpet under the quarter trim panel into position.
10. Install lower B-pillar trim covers.
11. Install sliding door sill plates.
12. Install front carpet trim ring and cover (Fig. 7).
13. Install seat belt anchors at the passenger side B-pillar and driver side C-pillars
14. Install kick plate and heel pad at the gas pedal
15. Install winch plug (spare tire winch) (Fig. 6).
16. Install front cowl panels and sill plates.
17. Install heel blocker (plastic block below accelerator pedal).
18. Install the floor console base tray and disconnect wire connector from the base tray.
19. Install instrument panel lower console.
20. Install front seats.
21. Install floor mats.