Carpets and Floor Mats

CARPETS AND FLOOR MATS

REMOVAL

1. Remove front seats.
2. Remove front center console.
3. Remove heel blocker (plastic block below accelerator pedal).
4. Remove the remaining seats.
5. Remove front cowl panels and sill plates.
6. Remove sliding door sill plates. Refer to Trim Panel.
7. Remove the cargo organizer, if equipped.
8. Remove liftgate scuff plate. Refer to Trim Panel.
9. Remove lower B-pillar trim covers.
10. Remove D-pillar trim covers.
11. Remove Quarter trim panels.

Fig. 4:

12. Remove floor escutcheons (Fig. 4).
13. Remove the floor console trays.
14. Remove push pin fasteners attaching carpet to floor in front seat and rear area.
15. Roll carpet from under instrument panel to center of sliding door.
16. Roll and fold carpet forward away from rear door opening.

Fig. 5:

17. Extract carpet through sliding door opening (Fig. 5).

INSTALLATION
1. Insert carpet through sliding door opening.
2. Roll carpet rearward toward rear door opening.
3. Roll carpet under instrument panel.
4. Install push pins fasteners through carpet and grommet into floor to attach carpet to floor in front seat area (Fig. 5).
5. Install push pins fasteners in the rear area.

CAUTION: Ensure that the correct fasteners are installed in the proper locations. Damage to the fuel tank may result.

6. Install floor escutcheons (Fig. 4).
7. Install the floor console trays.
8. Install Quarter trim panels.
9. Install D-pillar trim covers.
10. Install lower B-pillar trim covers.
11. Install rear door sill plate.
12. Install sliding door sill plates.
13. Install front cowl panels and sill plates.
14. Install the passenger seats.
15. Install front center console.
16. Install heel blocker (plastic block below accelerator pedal).
17. Install front seats.