RG Models

REMOVAL
1. Disconnect and isolate the negative battery cable.
2. Remove the air cleaner housing from the right side of the engine compartment.
3. Remove the windshield wiper assembly from the vehicle.
4. If equipped with rear A/C, disconnect the liquid and suction lines from the A/C expansion valve.

Evaporator Temperature Sensor (RG Models) - Rear A/C Shown:

5. Remove the retainer that secures the evaporator temperature sensor to the A/C expansion valve.

NOTE: To disconnect the wire harness connector from the evaporator temperature sensor, first push the red retaining ring toward the connector to release the lock, then disconnect the connector from the sensor.

6. Remove the evaporator temperature sensor from the A/C expansion valve and disconnect the wire harness connector.

INSTALLATION

NOTE: Any grease removed with the evaporator temperature sensor must be replaced. Failure to do so could result in poor A/C performance.

1. Position the evaporator temperature sensor into the right rear corner of the engine compartment.

NOTE: To connect the wire harness connector to the evaporator temperature sensor, first connect the connector to the sensor, then pull the red retaining ring toward the sensor.

2. Connect the wire harness connector to the evaporator temperature sensor.
3. Install the evaporator temperature sensor onto the top of the expansion valve with the sensor probe inserted into the well in the expansion valve.
4. Install the temperature sensor retainer.
5. If equipped with rear A/C, connect the liquid and suction lines to the A/C expansion valve and recharge the A/C system.
6. Install the window wiper module.
7. Install the air cleaner housing into the right side of the engine compartment.
8. Reconnect the negative battery cable.
9. Run the HVAC Cool Down test to verify system is operating properly.