Seat Belt & Retractor-Second Row-Right Outboard With Rear HVAC-LWB

REMOVAL
1. Remove first and second row seats.
2. Remove first row seat belt lower anchor bolt.
3. Remove first row seat belt upper anchor bolt.
4. Remove liftgate sill plate.
5. Remove upper liftgate trim.
6. Remove second seat belt lower anchor bolt.
7. Remove second seat belt upper anchor bolt.
8. Remove D-pillar trim cover.
9. Disconnect speaker connector. The left side has the speaker mounted in the D-pillar trim cover and the right side will have the speaker mounted in the rear of the quarter trim panel, but the connector is accessible from the rear after the D-pillar trim is removed.
10. Remove quarter trim bolster.
11. Remove quarter trim panel screws.
12. Remove quarter trim panel.
13. Loosen HVAC unit enough to gain access to seat belt retractor fasteners.

Trim Panel Mounting Bracket:

a. Remove bracket around HVAC unit.

Lower Heater Duct:

b. Remove air duct.

Rear HVAC Mounting:

c. Remove fasteners attaching HVAC unit to inner quarter panel.
d. Gently pry out on rear HVAC unit to gain access to the seat belt and retractor.

14. Remove bolts attaching seat belt guide loop to inner quarter panel.
15. Pull outward on HVAC unit and remove bolt attaching retractor to inner quarter panel.
16. Remove second row seat belt and retractor from vehicle.

INSTALLATION
1. Position second row seat belt and retractor to vehicle.
2. Pull outward on HVAC unit and install bolt attaching retractor to inner quarter panel. Torque bolt to 39 Nm (29 ft. lbs.).
3. Install bolts attaching seat belt guide loop to inner quarter panel.
4. Install fasteners attaching HVAC unit to inner quarter panel.
5. Install air duct.
6. Install trim panel retaining bracket around HVAC unit.
7. Install quarter trim panel.
8. Install quarter trim panel screws.
9. Install quarter trim bolster.
10. Connect speaker connector. The left side has the speaker mounted in the D-pillar trim cover and the right side will have the speaker mounted in the rear of the quarter trim panel, but the connector is accessible from the rear after the D-pillar trim is removed.
11. Install D-pillar trim cover.
12. Install second seat belt lower anchor bolt. Torque bolt to 39 Nm (29 ft. lbs.).
13. Install second seat belt upper turning loop anchor bolt. Torque bolt to 39 Nm (29 ft. lbs.).
14. Install upper liftgate trim.
15. Install liftgate sill plate.
16. Install first row seat belt upper turning loop anchor bolt. Torque bolt to 39 Nm (29 ft. lbs.).
17. Install first row seat belt lower anchor bolt. Torque bolt to 39 Nm (29 ft. lbs.).
18. Install first and second row seats.