B1D5D

B1D5D-ADJUSTABLE PEDAL SWITCH CIRCUIT STUCK REARWARD





^ When Monitored:
The Adjustable Pedals Switch is in active operation.
^ Set Condition:
The Seat Memory Module detects that the Adjustable Pedals Switch has been activated for a time period of more than 50 seconds.

Possible Causes

- CONNECTOR/TERMINAL DAMAGE
- (Q100) ADJUSTABLE PEDALS SWITCH FORWARD CIRCUIT SHORTED TO GROUND
- ADJUSTABLE PEDALS SWITCH - INTERNAL FAULT
- SEAT MEMORY MODULE - INTERNAL FAULT

Diagnostic Test

NOTE: This DTC must be active for the results of this test to be valid. CHECK FOR DTC B1D5D-ADJUSTABLE PEDAL SWITCH CIRCUIT STUCK REARWARD

Turn the ignition on.
With the scan tool, record and erase DTCs.
Cycle the ignition switch from off to on.
Cycle the Adjustable Pedals Switch forward and rearward.
With the scan tool, read DTCs
Does the scan tool display: B1D5D-ADJUSTABLE PEDAL SWITCH CIRCUIT STUCK REARWARD?
Yes >> Go To 2
No >> Refer to the INTERMITTENT CONDITION diagnostic procedure.
Perform APS VERIFICATION TEST - VER 1. Verification Tests

2. CHECK CONNECTOR/TERMINAL FOR DAMAGE





NOTE: Check all terminals for broken, bent, pushed out, or corroded terminals.

Turn the ignition off.
Inspect the Seat Memory Module harness connector, Adjustable Pedals Switch, and Adjustable Pedals Switch harness connector.
Is the Adjustable Pedals Switch or any of the connectors/terminals damaged?
Yes >> Repair as necessary.
Perform APS VERIFICATION TEST - VER 1. Verification Tests
No >> Go To 3

3. CHECK (Q100) AD ADJUSTABLE PEDALS SWITCH REARWARD CIRCUIT FOR A SHORT TO GROUND





Turn the ignition off.
Disconnect the Seat Memory Module harness connector.
Disconnect the Adjustable Pedals Switch harness connector.
Using a 12-volt test light connected to 12-volts, probe the (Q100) Adjustable Pedals Switch Rearward circuit.
Does the test light illuminate brightly?
Yes >> Repair the (Q100) Adjustable Pedals Switch Rearward circuit for a short to ground.
Perform APS VERIFICATION TEST - VER 1. Verification Tests
No >> Go To 4

4. CHECK ADJUSTABLE PEDALS SWITCH SHORTED





Turn the ignition off.
Disconnect the Adjustable Pedals Switch harness connector. Measure the resistance between the (Q100) Adjustable Pedals Switch Rearward and (Q900) Adjustable Pedals Switch Forward terminals at the Adjustable Pedals Switch.
Is the resistance below 5.0 ohms?
Yes >> Replace and reprogram the Seat Memory Module in accordance with the Service Information.
Perform APS VERIFICATION TEST - VER 1. Verification Tests
No >> Replace the Adjustable Pedals Switch in accordance with the Service Information.
Perform APS VERIFICATION TEST - VER 1. Verification Tests