Power Locks
B210E-BATTERY VOLTAGE HIGH - MEMORY MIRROR MODULEWHEN MONITORED
At all times.
SET CONDITION
Anytime the module senses voltage input above 15.9 volts, this code will set.
POSSIBLE CAUSES
- High voltage engine DTC
- Memory mirror module
Diagnostic Test
1.CHECK ENGINE DTC'S
With the scan tool, read ENGINE DTC's
Q: Are there any ENGINE DTC's present?
NO: Go to 2
YES: Refer to symptom list for problems related to ENGINE.
2. TEST FOR INTERMITTENT CONDITION
With the scan tool, record and erase DTC's Start the engine and run for 2 minutes.
Cycle the ignition from on to off 3 times.
Turn the ignition on.
With the scan tool, read DTC's.
Q: Does the scan tool display BATTERY VOLTAGE HIGH?
YES: Replace the Memory Mirror Module. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test
NO: The conditions that caused this code to set are not present at this time. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Perform BODY VERIFICATION TEST - VER 1. Body Verification Test