P1715

P1715-RESTRICTED MANUAL VALVE IN T3 RANGE

For the Transmission circuit diagram, refer to Wiring Diagram Information.
^ When Monitored:
Whenever the PRNDL code indicates Temp3.
^ Set Condition:
This DTC sets when conditions for the DTC P1776 are satisfied or 3 unsuccessful attempts to engage 1st gear while the shifter is in the temp3 zone. This indicates a restricted port at the manual valve because the shifter is not fully engaged in the drive position.

Possible Causes
- RELATED TRANSMISSION DTC'S PRESENT
- CUSTOMER DRIVING HABITS
- MISADJUSTED SHIFTER

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Verification Tests

Diagnostic Test
1. DETERMINING IF RELATED DTC'S ARE PRESENT
With the scan tool, check for other transmission DTC's
Are any of the following DTC's P0731, P0732, P0733, P0734, P1736 or P0715 present?
Yes >>Refer to the Transmission category and perform the appropriate symptom.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests
No >>Go To 2

2. CHECK SHIFTER ADJUSTMENT
Check Shifter adjustment per the Service Information.
Is the shifter properly adjusted?
Yes >>Go To 3
No >>Adjust the Shifter Assembly per the Service Information.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests

3. CHECK CUSTOMER DRIVING HABIT
This DTC can be set if the customer rests their hand on the shift lever while they are driving. The transmission can be put in the T3 position if just enough forward pressure is exerted on the shift lever.
When this occurs, the feed port to the clutch is restricted, the transmission will declare neutral, and this DTC will be set. The customer should be informed not to rest their hand on the shifter while driving.
This DTC can also be set by simply bumping the shift lever toward neutral while accelerating.
With the scan tool, check the EATX DTC EVENT DATA to help identify the conditions in which the DTC was set.
If there are no possible causes remaining, view repair.
Repair
This DTC can be set by putting too much forward pressure on the shift lever while it is in the OD position. Make sure the customer is informed.
Perform 45RFE/545RFE TRANSMISSION VERIFICATION TEST - VER 1. Verification Tests