U1412

U1412-IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED

U1412-Implausible Vehicle Speed Signal Received:

WHEN MONITORED
Ignition on.

SET CONDITION
The PCM gets an implausible signal over the CAN C circuit from the ABS Module. The circuit is continuously monitored.

POSSIBLE CAUSES
- CAN C BUS Circuit shorted
- CAN C BUS Circuit open
- ABS module
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Theory of Operation
The ABS Module sends vehicle speed information over the CAN C Bus circuit to the PCM.

DIAGNOSTIC TEST

1. ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read DTCs.

Q: Is the U1412-IMPLAUSIBLE VEHICLE SPEED SIGNAL RECEIVED active at this time?

YES: Go To 2
NO: Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

2. U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT IS ACTIVE
Continue reading DTCs.

Q: Is the U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT ACTIVE at this time?

YES: Refer to the Diagnostic Procedure for the U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT.
NO: Go To 3

3. ABS MODULE IS ACTIVE ON THE CAN C BUS
With the scan tool, select ECU View.
Verify that the ABS Module active on the bus.

Q: Is the ABS Module active on the bus?

YES: Go To 4
NO: Perform BODY VERIFICATION TEST VER 1.

4. ACTIVE DTCS IN THE FCM
With the scan tool, select ECU View and select FCM.
With the scan tool, read active DTCs.

Q: Is the U0001-NO COMMUNICATION ON THE CAN C BUS CIRCUIT ACTIVE in the FCM at this time?

YES: Replace the ABS Module per Service Information.
Perform BODY VERIFICATION TEST VER 1.
NO: Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test