U1417

U1417-IMPLAUSIBLE LEFT WHEEL DISTANCE SIGNAL RECEIVED

U1417-Implausible Left Wheel Distance Signal Received:

WHEN MONITORED
Ignition on.

SET CONDITION
The PCM gets an implausible signal over the CAN C circuit from the ABS Module. The circuit is continuously monitored.

POSSIBLE CAUSES
- Vehicle speed sensor fault active in anti-lock brake module
- CAN C BUS Circuit shorted
- CAN C BUS Circuit open
- ABS module
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Theory of Operation
The ABS Module sends an implausible distance signal over the CAN C Bus circuit to the PCM.

DIAGNOSTIC TEST

1. ACTIVE DTC
Ignition on, engine not running.
With a scan tool, read DTCs.

Q: Is the U1417-IMPLAUSIBLE LEFT WHEEL DISTANCE SIGNAL RECEIVED active at this time?

YES: Go To 2
NO: Refer to the INTERMITTENT CONDITION Diagnostic Procedure. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test

2. ABS MODULE IS ACTIVE ON THE CAN C BUS
With the scan tool, select ECU View.
Verify that the ABS Module active on the bus.

Q: Is the ABS Module active on the bus?

YES: Go To 3
NO: Refer to Body Control Module Testing for diagnostic procedures and for further possible causes.


3. DTCS STORED OR ACTIVE IN THE ABS MODULE
Check for DTCs in the ABS Module.

Q: Are any DTCs active or stored in the ABS Module?

YES: Refer to ABS ELECTRICAL DIAGNOSTICS and perform the diagnostics for the DTCs in the ABS Module.
Perform ABS VERIFICATION TEST VER 1.
NO: Go to 4

4. ACTIVE DTCS IN THE FCM
With the scan tool, select ECU View and select FCM.
With the scan tool, read active DTCs.

Q: Are any Communication DTCs active in the FCM relating to the ABS System?

YES: Replace the ABS Module per Service Information. Perform BODY VERIFICATION TEST VER 1.
NO: Replace and program the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test