42RLE Transmission Verification Test

42RLE TRANSMISSION VERIFICATION TEST - VER 1

1. After completion of the Transmission Verification Test, a Powertrain Verification Test must be performed.
2. Connect the scan tool to the Data Link Connector (DLC).
3. Reconnect any disconnected components.
4. With the scan tool, erase all Transmission DTCs, also erase the PCM DTCs.
5. Perform *PRNDL FAULT CLEARING PROCEDURE after completion of repairs for P0706 CHECK SHIFTER SIGNAL.
6. With the scan tool, display Transmission Temperature. Start and run the engine until the Transmission Temperature is above 43°C (110°F).
7. Check the transmission fluid and adjust if necessary. Refer to the Service Information for the Fluid Fill procedure.
8. If the Powertrain Control Module or Torque Converter has been replaced, or if the Transmission has been repaired or replaced, perform a Quick Learn Procedure and reset the Pinion Factor with the scan tool.
9. Road test the vehicle. With the scan tool, monitor the engine RPM. Make 15 to 20 1-2, 2-3, 3-4 upshifts. Perform these shifts from a standing start to 45 Mph. with a constant throttle opening of 20 to 25 degrees.
10. Below 25 MPH, make 5 to 8 wide open throttle kickdowns to 1st gear. Allow at least 5 seconds each in 2nd and 3rd gear between each kickdown.
11. For a specific DTC, drive the vehicle according to the DTC When Monitored and Set Conditions in order to verify that the DTC is repaired.
12. If equipped with AutoStick, upshift and downshift several times using the AutoStick feature during the road test.
13. Where applicable, use the EATX OBDII task manager to run Good Trip time in each gear. This will confirm the repair.
14. Check for Diagnostic Trouble Codes (DTCs) after the road test. If a DTC sets during the road test, return to the Symptom list and perform the appropriate diagnostic procedure.
15. Erase the Engine DTC P0700 to turn the MIL off after making transmission repairs.
Were there any DTCs set during the road test?
Yes >>Refer to the Symptom List and perform the appropriate diagnostic procedure.
No >>Repair is complete.