Quarter Panel Trim

PANEL-QUARTER TRIM

REMOVAL




1. Remove the C-pillar trim. Refer to Trim Panel.
2. Remove the rear screw (1).
3. Remove the tie down anchor bolt (2) and tie down (3).
4. Remove the three front screws (4) and separate the trim panel.
5. Disconnect the power outlet electrical connector, if equipped.

INSTALLATION




1. Connect the power outlet electrical connector, if equipped.
2. Position the trim panel onto the quarter panel and seat the retaining clips fully.
3. Install the three forward screws (4).
4. Install the rear screw (1).
5. Install the tie down (3) and tie down anchor bolt (2).
6. Tighten the bolt to 12 N.m (9 ft.lbs.).
7. Install the C-pillar trim.