Trailer Lamps: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Reach behind the bracket (6) on the trailer hitch receiver to access and disconnect the connector (5) of the chassis wire harness (4) from the 7-way trailer tow connector (2), or to disengage the 4-way trailer tow connector (3) from the bracket.
3. Remove the four screws (1) that secure the 7-way trailer tow connector to the bracket.
4. Remove the 7-way trailer tow connector from the bracket.

INSTALLATION




1. Position the 7-way trailer tow connector (2) into the bracket (6) on the trailer hitch receiver.
2. Install and tighten the four screws (1) that secure the 7-way trailer tow connector to the bracket. Tighten the screws to 4 Nm (35 in. lbs.).
3. Reach behind the bracket to access and reconnect the connector (5) of the chassis wire harness (4) from the 7-way trailer tow connector, or to engage the 4-way trailer tow connector (3) to the bracket.
4. Reconnect the battery negative cable.