Rear

REMOVAL




1. Disconnect and isolate the negative battery cable.
2. Remove the right rear quarter interior trim panel.
3. Disconnect the rear HVAC wire harness connector (1) from the rear blower motor resistor (2).
4. Remove the screw (3) that secures the rear blower motor resistor to the rear HVAC housing (4).
5. Remove the rear blower motor resistor from the rear HVAC housing.

INSTALLATION




1. Position the rear blower motor resistor (2) into the rear HVAC housing (4).
2. Install the screw (3) that secures the rear blower motor resistor to the rear HVAC housing. Tighten the screw to 2 N.m (17 in. lbs.).
3. Connect the rear HVAC wire harness connector (1) to the rear blower motor resistor.
4. Install the right rear quarter interior trim panel.
5. Reconnect the negative battery cable.