Rear

REMOVAL




1. Remove the rear HVAC housing . Removal and Replacement
2. Remove the rear blend door actuator.
3. Carefully remove the foam seal (1) from the rear heater core and evaporator extension line flange (3). If the seal is deformed or damaged, it must be replaced.
4. Remove the screws (2) that secure the two halves of the rear heater core and evaporator extension line flange together.
5. Remove the outer half of the rear heater core and evaporator extension line flange.




6. Remove the screw (1) that secures the rear heater core tube retaining bracket (2) to the rear HVAC housing (3).
7. Remove the rear heater core tube retaining bracket.
8. Carefully pull the rear heater core (4) out of the side of the rear HVAC housing.

INSTALLATION




1. Install the rear heater core (4) into the side of the rear HVAC housing (3). Make sure that the insulator is properly installed.
2. Install the rear heater core retaining bracket (2).
3. Install the screw (1) that secures the rear heater core retaining bracket to the rear HVAC housing. Tighten the screw to 2 N.m (17 in. lbs.).




4. Install the outer halve of the rear heater core and evaporator extension line flange (3).
5. Install the screws (2) that secure the two halves of the rear heater core and evaporator extension line flange together. Tighten the screws to 2 N.m (17 in. lbs.).
6. Install the foam seal (1) to the rear heater core and evaporator extension line flange.
7. Install the rear blend door actuator.

NOTE: If the heater core is being replaced, flush the cooling system. Service and Repair

8. Install the rear HVAC housing.