Nozzle-Liftgate Washer
REMOVALNOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
1. Using a trim stick or another suitable wide flat-bladed tool, gently pry at the bottom of the rear washer nozzle (2) to release the latch feature that secures it in the mounting hole of the liftgate outer panel (3).
2. Pull the rear washer nozzle out from the liftgate outer panel far enough to access the washer hose (1).
3. Disconnect the hose from the barbed nipple on the back of the nozzle.
4. Discard the nozzle.
INSTALLATION
NOTE: The rear washer nozzle latch feature is a one time component, and will be damaged if the nozzle is removed from its mounting hole for service. If removed from its mounting hole for any reason, the rear washer nozzle must be replaced with a new unit.
1. Position the new rear washer nozzle (2) to the mounting hole in the liftgate outer panel (3). Be certain that the rubber gasket is in position on the back of the nozzle.
2. Reconnect the washer hose (1) to the barbed nipple on the back of the nozzle.
3. Push the hose and nozzle nipple into the mounting hole in the liftgate outer panel and engage the tab located above the nipple with the upper edge of the hole.
4. Using hand pressure, push firmly and evenly on the lower edge of the nozzle until it snaps into place.