Front Door Latch: Service and Repair

LATCH

REMOVAL




1. Remove the watershield. Refer to Front Door panel.
2. Remove the bolt (3) and nut (2) and position aside the rear glass run channel (1).




3. Remove the latch screws (5).
4. Disconnect the actuator rods (3).
5. Disconnect the electrical connectors (6) and remove the latch.

INSTALLATION




1. Install the latch into the door.
2. Connect the electrical connectors (6).
3. Connect the actuator rods (3).
4. Install the screws and tighten to 10 N.m (85 in.lbs.).
5. Adjust the latch as needed.




6. Position the rear glass run channel back and install the nut and bolt.
7. Tighten the fasteners to 8 N.m (70 in.lbs.).
8. Install the watershield.