Acceleration/Deceleration Sensor: Service and Repair
SENSOR-GREMOVAL - 4X4 WITH TRACTION CONTROL
1. Disconnect the battery.
2. Remove the IP top cover (1) for access to the sensor (3).
3. Disconnect the sensor harness (4).
4. Remove the sensor mounting bolt (2) and remove the sensor (3).
INSTALLATION - 4X4 WITH TRACTION CONTROL
CAUTION: The G-sensor (3), will not function properly if the sensor is installed incorrectly. Verify that the sensor is correctly installed when the electrical connector (4) is pointing toward the passenger side of the vehicle.
NOTE: If the G-sensor (3) was mounted incorrectly in the area designed for the GPS antenna, the G-sensor will be off 90 ° and not function properly.
1. Install the sensor (3) and tighten the mounting bolt (2) to 5.6 Nm (50 inch lbs.).
2. Connect the harness (4) to the sensor (3). Be sure the harness connector (4) is firmly seated.
3. Install the IP top cover (1).
4. Reconnect the battery.