Rear
SENSOR-WHEEL SPEED-ABS-REARREMOVAL
WITH TRACTION CONTROL
1. Raise the vehicle on a hoist.
2. Disconnect the wheel speed sensor electrical connector (3).
3. Remove the mounting bolt (1) from the sensor (4).
4. Remove the sensor (4) from the brake caliper adapter (2).
WITHOUT TRACTION CONTROL
1. Raise the vehicle on a hoist.
2. Disconnect the sensor wire harness.
3. Remove the brake line mounting nut and remove the brake line from the sensor stud (2).
4. Remove the mounting stud (2) from the sensor (1) and shield.
5. Remove the sensor (1) and shield from the differential housing (3).
INSTALLATION
WITH TRACTION CONTROL
1. Insert the wheel speed sensor (4) in the brake caliper adapter (2).
2. Install the sensor mounting bolt (1) and tighten to 24 Nm (200 inch lbs.).
3. Reconnect the electrical wiring connector (3) to the sensor (4).
4. Lower the vehicle.
WITHOUT TRACTION CONTROL
1. Install the O-ring on the sensor (1) (if removed).
2. Insert the sensor (1) in the differential housing (3).
3. Install the sensor shield.
4. Install the sensor mounting stud (2) and tighten to 24 Nm (200 inch lbs.).
5. Install the brake line on the sensor stud (2) and install the nut.
6. Connect the harness to the sensor. Be sure the seal is securely in place between the sensor and the wiring connector.
7. Lower the vehicle.