Junction Block

REMOVAL




1 Disconnect and isolate the battery negative cable.
2. Remove the cowl trim cover (Refer to BODY/INTERIOR/COWL TRIM COVER - REMOVAL).
3. Remove the mounting fasteners (3).
4. Disconnect the electrical harness connectors and remove Junction Block (1).
5. Transfer components as necessary.

INSTALLATION




1 Connect wire harness connectors to the Junction Block (JB) (1).
2. Position JB and install mounting fasteners (3).
3. Install cowl trim cover (Refer to BODY/INTERIOR/COWL TRIM COVER - REMOVAL).
4. Connect the battery negative cable.