Service Procedure

IMPORTANT:
The StarSCAN tool being used must be at software level 5.02 or higher. The StarSCAN software level is displayed in the upper right corner of the tool's display screen.

1. Install a battery charger and verify that the charging rate provides approximately 13.5 volts.

2. Connect the StarSCAN to the data link connector located below the steering column.

3. Turn the ignition key to the "RUN" position.

4. Power ON the StarSCAN.

5. Starting at the StarSCAN "Home" screen, calibrate the instrument cluster gauges using the following procedure:

a. Select "ECU View

b. Browse the list displayed on the StarSCAN screen using the scroll arrows and highlight "CCN Cabin Compartment".

c. Select "Misc. Functions".

d. Select "Check Cluster Calibrations

e. Press the "Start" button on the screen.

f. Follow the on-screen instructions and perform prompts as required.

6. Check all modules for Diagnostic Trouble Codes (DTC's) using the following procedure:

NOTE:
Due to the calibration procedure, a DTC may be set in other modules (PCM, TCM, FCM, CCN, WCM, etc.) within the vehicle, if so equipped. Some DTC's may cause the MIL to illuminate.

a. Press the "Show Short Cuts" button.

b. Press the "Home" button.

c. Press the "System View" button.

d. Press the "All DTC's" button.

e. Press the "Clear All Stored DTC's" button.

f. Press the "Yes" button.

7. Disconnect the StarSCAN tool from the vehicle data link connector.

8. Return the vehicle to the customer.