Wiper Control Module: Service and Repair

REMOVAL




1. Disconnect and isolate the battery negative cable.
2. Remove the wiper arms (1) and (2).




3. Remove the cowl panel (1).




4. Disconnect the wiper motor electrical connector (1).




5. Remove the two retaining bolts (1 and 4) and remove wiper module (3) from vehicle.

INSTALLATION




1. Inspect the grommet (1) that the wiper motor sits in. If cracked, brittle, or damaged, replace the grommet (1).




2. While positioning the wiper module in its mounting location, make sure that the dowel on the bottom of the wiper motor (1) slides into the mounting grommet (2) correctly.




3. Install the two retaining bolts (1 and 4). Torque bolts to 8 N.m (70 in.lbs.).




4. Connect the wiper motor electrical connector (1).




5. Install the cowl panel (1).




6. Install the wiper arms (1) and (2). Torque nuts to 18 N.m (150 in.lbs.).
7. Connect the battery negative cable.