Front-AWD

SENSOR-FRONT WHEEL SPEED-AWD

REMOVAL
1. Raise and support vehicle.





NOTE: To remove sensor connector from body wiring harness connector, move retaining clip (2) and pull sensor connector outward.





2. Remove sensor cable routing clip (2) from brake hose bracket (3).
3. Remove sensor connector (1) from body wiring harness connector (4).





4. Remove screw (1) fastening wheel speed sensor (2) to knuckle (4). Pull sensor head out of knuckle.
5. Remove wheel speed sensor cable routing clip (3) from knuckle (4).
6. Remove wheel speed sensor (2).

INSTALLATION





1. Install wheel speed sensor (2) head into knuckle (4) and install mounting screw (1). Tighten screw to 11 Nm (95 inch lbs.) torque.
2. Attach wheel speed sensor cable and routing clip (3) to knuckle (4).





3. Attach sensor cable routing clip (2) to brake hose bracket (3).
4. Connect sensor connector (1) to body wiring harness connector (4). When installing connector, make sure retaining clip on body connector is properly in place and sensor connect cannot be pulled out.
5. Lower vehicle.
6. Perform Verification Test and clear any faults.