D. Torque Converter Replacement

D. Torque Converter Replacement:

1. Remove the transmission oil pan and drain old oil. Temporarily install the transmission oil pan.

2. Replace the transmission torque converter. Follow the detailed repair procedures on TechCONNECT - SERVICE INFO tab / 21 - Transmission Transaxle / Automatic - NAG1 / Torque Converter / Removal and Installation.

NOTE:
During transmission installation, do not install the 13-way electrical harness connector to the transmission, do not install the transmission oil fill tube, and do not add new transmission fluid to the transmission.

NOTE:
Immediately prior to transmission installation, it will be important to check the converter seating with a scale and straightedge to prevent damage to the torque converter or oil pump. Surface of converter lugs should be at least 19 mm (314 in.) to rear of straightedge when converter is fully seated.

NOTE:
To not contaminate the new torque converter with the old transmission oil. DO NOT start vehicle or add transmission oil to the transmission at this time. In the following sections, the old transmission oil must be drained entirely from the transmission and oil cooler. The old transmission filter and oil fill tube seal must be replaced. Once this is completed, a flush and fill of the transmission oil must be performed six ( 6) times for vehicles that have had a torque converter replaced.

3. Proceed to Section E - Transmission Oil Drain.