Installation

INSTALLATION
1. Install transaxle assembly to engine. Install and torque transaxle-to-engine bolts to 108 Nm (80 ft. lbs.).
2. Raise engine/transaxle assembly into position with screwjack and wood block.
3. Install and torque transaxle upper mount-to-rail through-bolt to 118 Nm (87 ft. lbs.).
4. Remove transmission jack and screw jack supports.
5. Install torque converter-to-drive plate bolts and torque to 88 Nm (65 ft. lbs.).
6. Install converter dust shield.
7. Install and torque right lateral bending brace-to-transaxle bolt to 81 Nm (60 ft. lbs.).
8. Install starter motor assembly
9. Install left lateral bending brace. Torque brace-to-transaxle case bolts to 108 Nm (80 ft. lbs.). Torque brace-to-engine bedplate bolt to 54 Nm (40 ft. lbs.). Torque brace-to-intake manifold bolt to 28 Nm (200 inch lbs.).
10. Install structural collar.
11. Install power steering oil cooler.
12. Install halfshafts.
13. Lower vehicle.
14. Install gearshift cable to mount. Secure cable end to manual valve lever.
15. Install solenoid/pressure switch assembly connector.
16. Connect input speed sensor connector.
17. Connect output speed sensor connector.
18. Install cooler lines with service splice kit. Refer to instructions provided with kit.
19. Install air cleaner/throttle body assembly.
20. Install battery tray.
21. Install battery and hold down.
22. Connect battery cables.
23. Fill transaxle with suitable amount of fluid.