Accelerometer 2
ACCELEROMETER 2WHEN MONITORED
With the ignition on. The module's on board diagnostics continuously performs internal circuit tests.
SET CONDITION
This DTC will set if the module identifies an out of range internal circuit.
POSSIBLE CAUSES
- Occupant restraint controller
Diagnostic Test
1. DETERMINE ACTIVE OR STORED DTC
Turn the ignition on.
NOTE:
- Ensure the battery is fully charged.
- When reconnecting airbag system components the Ignition must be turned off and the Battery must be disconnected.
Select ACTIVE or STORED DTC
ORC - ACTIVE DTC
Go To 2
ORC - STORED DTC
Test Complete.
2. OCCUPANT RESTRAINT CONTROLLER (ORC)
WARNING:
- TO AVOID PERSONAL INJURY OR DEATH, DISCONNECT THE BATTERY AND WAIT TWO MINUTES BEFORE PROCEEDING.
- WARNING: IF THE OCCUPANT RESTRAINT CONTROLLER IS DROPPED AT ANY TIME, IT MUST BE REPLACED. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND PERSONAL INJURY OR DEATH.
View repair.
Repair
Replace the Occupant Restraint Controller (ORC). Perform ORC VERIFICATION TEST - VER 1. Occupant Restraint Controller (ORC) Verification Test