P060E

P060E-ETC LEVEL 2 TPS PERFORMANCE


WHEN MONITORED
Throttle motor is powered and no matured faults related to TP Sensors.

SET CONDITION
When secondary software determines that TPS 1 and TPS 2 signals do not match for a period of time. ETC lamp will flash.

POSSIBLE CAUSES
- PCM needs to be programmed
- PCM

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Diagnostic Test

1. PROGRAM THE POWERTRAIN CONTROL MODULE
Verify the PCM is at the latest calibration (flash level).

NOTE: An intermittent loss of power to the PCM without performing an ETC Relearn procedure may cause this DTC to set.

Flash the Powertrain Control Module per Service Information if any updates are available.
Start the engine.
Allow the engine to reach normal operating temperature.
Operate the accelerator pedal. (do not exceed 3500 RPM)
With a scan tool, read DTCs.

NOTE: Diagnose any other DTCs that may have set with the P060E.

Q: Does this DTC reset by itself?

YES: Replace and reprogram the Powertrain Control Module per Service Information. Perform the POWERTRAIN VERIFICATION TEST. Powertrain Verification Test
NO: Test Complete.