Lower Side Moulding / Trim: Service and Repair
BODY SIDE MOLDINGSNOTE: Quad Cab model shown in the illustration. Body side moldings for Regular cab models are similar.
REMOVAL
1. As a guide for installation, apply a length of masking tape on the rocker panels (1), parallel to the top edge and, to one end of the body side molding (2 and 3) being removed
CAUTION: Do not exceed 52 degrees C (120 degrees F) when heating the moldings or rocker panels. Failure to follow this caution may result in damage to the moldings and/or the vehicle paint finish.
2. If the temperature is below 21 degrees C (70 degrees F), warm the body side moldings with a heat lamp or heat gun.
NOTE: The body side moldings are attached to the cab with adhesive tape.
3. Using a trim stick C-4755 or equivalent, carefully remove the moldings from the rocker panels, as necessary.
INSTALLATION
1. Thoroughly clean all residue from the molding attachment areas of the rocker panels (1).
2. Wipe the attachment areas with a clean, lint-free cloth, moistened with a 50% solution of water and alcohol and then wipe dry the areas immediately with a dry, lint-free cloth.
CAUTION: Do not exceed 52 degrees C (120 degrees F) when heating the moldings or rocker panels. Failure to follow this caution may result in damage to the moldings and/or the vehicle paint finish.
NOTE: If ambient temperatures are below 21 degrees C (70 degrees F), warm the body side molding and rocker panel with a heat lamp or gun to assure proper adhesion.
3. Remove the protective covering from the back of the body side molding (2 and 3) and position the molding onto the rocker panel using the previously installed guide tape.
NOTE: To ensure proper molding adhesion, apply consistent and uniform pressure of approximately 40 p.s.i. over the entire surface of each body side molding.
4. Install the body side molding onto the rocker panel.