Power

REMOVAL




1. Remove the inner belt molding.
2. Remove the waterdam.
3. Remove the electric window switch from the door trim panel and connect it to the door wire harness.
4. Raise the door glass to the position shown.
5. Remove the two nuts (1) that secure the door glass (2) to the window regulator (3) through the speaker opening (4) and the sight window (5) and disengage the door glass from the regulator.
6. Position the door glass to the full up position and secure the glass using a wooden wedge or an equivalent.




7. Lower the window regulator (2) and remove the two nuts that secure the regulator stabilizer to the door.
8. Remove the lower bolt (1) that secures the window regulator to the door and loosen the other two regulator bolts.
9. Slide the window regulator upward and disengage the two regulator bolts from the door.
10. Remove the window regulator through the opening in the door and disconnect the door wire harness (3).

INSTALLATION




1. Connect the door wire harness (3) to the window regulator (2) and install the regulator through the opening in the door.
2. Engage the two upper regulator bolts (1) to the door.
3. Install the lower regulator bolt that secures the window regulator to the door and tighten all three regulator bolts to 10 N.m (89 in.lbs.).
4. Position the regulator stabilizer into the door and install the two nuts. Tighten the nuts to 10 N.m (89 in.lbs.).




5. Raise the window regulator (3) to the position shown.
6. Support the door glass (2) and remove the wooden wedge or equivalent.
7. Position the door glass to the window regulator and install the two nuts (1) that secure the door glass to the window regulator (3) through the sight window (4) and the speaker opening (5). Tighten the nuts to 10 N.m (89 in.lbs.).
8. Disconnect the electric window switch from the door wire harness and reinstall the switch onto the door trim panel.
9. Install the waterdam.
10. Install the inner belt molding.